Our website uses cookies provided by us and third parties. Some cookies are necessary for the operation of the website, and you can adjust other cookies at any time, especially those that help us understand the performance of the website, provide you。

I accept
Name:
Phone Number:
Company Name:
mailbox:
Content:
Contact Us
Send Email
English
  • 全球-简体中文
  • Global-English
  • Service &Support

    Product FAQ

    Product FAQ

    Probe Station Laser Repair System Software

    • Q
      Eyes get tired easily
      A

      1 the pupil distance of binocular head does not match that of the operator, so the pupil distance of binocular head needs to be adjusted;2. The eyepiece's visual degree is not adjusted correctly, and the eyepiece's visual degree needs to be adjusted;

    • Q
      The image is clear on one side and blurry on the other
      A

      1. When the sample is placed in an inclined position, the sample should be put flat;2. The objective lens is not tightened, so the sample table should be adjusted to tighten the objective lens horizontally

    • Q
      Microscopic image quality variation
      A

      1. Dirty eyepiece lens, dirty tube lens, clean the dirty area of eyepiece lens, objective lens and tube lens;2. If the aperture light bar is too large or too small, adjust the aperture light bar;3. Do not adjust the focus, adjust the focusing handwheel;4. Cover the sample with media such as cover glass, and remove the media such as cover glass.

    • Q
      The field of view of the microscope is not bright enough, the edges are cut or cannot be seen
      A

      1. the converter is not in the positioning position, need to turn the converter to the positioning position 2. the mirror dial is not in the positioning position, need to turn the mirror dial to the positioning position 3. The brightness of the lighting is insufficient, adjust the brightness of the light source or increase the aperture of the light bar 4. There may be no eyepiece installed, need to install the eyepiece.

    • Q
      After moving the sample, the picture becomes blurred
      A

      1. non-vertical microscope 2. sample sets not horizontal 3. sample uneven solution :1 adjust the vertical microscope 2 adjust the horizontal sample set 3 adjust the sample to the horizontal

    目前在第1页, 共有2页, 共有7条记录 第一页 上一页 12 下一页 最后一页 跳转到
    © 2020 SEMISHARE CO., LTD. All Rights Reserved.ICP 19119103